# How To Tell A Load Bearing Wall

How To Tell A Load Bearing Wall. When determining a header size load bearing wall, measure the span in feet and add two to that number. Look for the walls in the center of the house.

Determine whether anything is resting on top of the wall. Many times, if the joists run perpendicular to the wall, it is load bearing. If the drywall is open, this process will be much easier.

### One Of The Best Ways To Figure Out Whether A Wall Is Load Bearing Is To Check If Joists Are Sitting On Top Of It.

Use a stud finder along the ceiling next to the wall in question and see if any joists running perpendicular to it are present. If you have walls built in the same place on each floor of the home, those walls are all most likely load bearing. You should always assume that a wall that interfaces directly with a sturdy.

### Let The Load Bearing Wall Pros Show You How To Identify A Load Bearing Wall.

Identify if the wall runs through multiple levels. You will need to look at the floor/ceiling joists. If you have a basement, that would be the best place to check first.

### Joists Below The Roof Or Floor Act As Beams In The Case Of Flat Roofs.

The attic can give you an overall view of the house's weight distribution. Determine whether anything is resting on top of the wall. For example, if the span is four feet, add 2 to 4 for a sum of 6.

### 4) Basic Steps To Determine Load Bearing Walls.

Start at the lowest point of the house. Trusses, used to transmit and carry the roof’s load to the wall, are substituted for joists. You can do this in a couple of ways:

### For Example, If There Are Any Walls Below The Vertical Beams In Figures 3 And 4, Those Walls Are Almost Surely Load Bearing.

The sum will be the height of your double header in inches. When joists/trusses are perpendicular to the wall and bear on the top of the wall, that wall is bearing wall. Many times, if the joists run perpendicular to the wall, it is load bearing.